iPod Classic External Antenna Install | Boxy Pixel

0.0 Before You Begin

0.1 Materials Needed

• iPod Classic donor unit
• External Antenna
• Razor blade

1.0 Initial Testing

Before adding the external antenna, I would suggest testing your Bluetooth range to verify you need it.

2.0 Assembly

In order to use an external antenna, you need to disconnect the internal antenna. (zig zag line on the blue board).  One method is to simply cut the Bluetooth board along the dotted line as shown.  Then, plug in your external antenna and add Kapton tape to the brass antenna connector to prevent shorting on your rear iPod housing. Note: The image below shows some test parts and where to cut.  The switch does not need to be removed.

 

3.0 Troubleshooting

If you run into trouble, this working troubleshooting document may help:

Boxy Pixel MKII troubleshooting document

Note: Boxy Pixel specializes in precision housings and housing design. iPod software modifications, iFlash setup, and donor iPod issues may require additional research or support from those specific communities.