iPod Custom PCB - Bluetooth and Type-C charge: Generation 5, 6, 7

This is a preorder item that has an anticipated close date of September 25th. Estimated time for parts to arrive here at Boxy Pixel is end of November/Early December. If are ordering non-preorder items, they will be sent in one package when the pre-order items arrive. Thank you for your patience!

If you'd like to add bluetooth and type-C charging to your classic iPod, try out our Boxy Pixel PCB that does just that! This is designed to drop into our custom iPod housings. Simply slide in your connections using our included flex cables, and secure in place. 

Features

• Type-C charging and Bluetooth board come soldered on, ready for install
• There are connection points (soldering required) for adding
  • Taptic engine
  • Magsafe charging coil
• 3.5mm headphone jack 
• Two switches on top, one for turning Bluetooth on/off, and another for the hold switch
• 1 button on the rear for syncing the Bluetooth board
• Bluetooth uses the KCX BT emitter board (supports sbc and aac)

Includes

• 1x Front housing
  
• 1x Rear housing
• 1x Retainer

Warnings

• This electronics board will not fit OEM housings
• The bluetooth board will not connect with all headphones.  I have begun to compile a list of headphones that work, see here.
• This will not work with 3.5mm headphones that have a microphone